East Palestine Internet, Inc.
1. From the desktop, double-click My Computer.
2. Double-click Dial-up Networking.
3. If you receive a message stating that The phonebook is empty..., then click
OK to add a new entry.
4. If Dial-up Networking (DUN) already has other phone book entries, click
New.
5. If the New Phonebook Entry Wizard window appears, check the box labeled
I know all about phonebook entries... and click Finish.
6. In
the New Phonebook Entry dialog, select the Basic tab.
7. Check Use Telephony dialing properties.
8. Uncheck Use another port if busy.
9. For Entry name, enter EPI.
10. Enter the country code and area code of the number you are dialing, plus
the phone number itself.
11. Under Dial using, select your modem.
12. Click
the Configure button.
13. Set the Initial speed (BPS) to 19,200 if you have a 14.4k modem or 38,400
if you have a 28.8k modem.
14. Make sure all three Hardware Features boxes are checked (if applicable)
and that Disable modem speaker is not checked.
15. Click
the OK button.
16. Select the Server tab.
17. The Dial-up server type should be PPP: Windows NT, Windows 95 Plus, Internet.
18.For Network Protocols only TCP/IP should be checked.
19. Make sure Enable software compression is checked, but Enable PPP LCP extensions
unchecked.
20. Click
the TCP/IP settings button.
21. Select Server assigned IP address and Specify name server addresses.
22. In the Primary DNS text box, type 198.30.168.11
23. In the Secondary DNS text box, type 198.30.168.12
24. Leave the Primary WINS and Secondary WINS servers at 0.0.0.0.
25. Check both Use IP header compression and Use default gateway on remote
network.
26. Click
the OK button.
27. Select the Script tab.
28. Make sure None is selected.
29. Select the Security tab.
30. Select Accept any authentication including clear text.
31. On
the New Phonebook Entry window, click OK.
32. You will now be in the Dial-up Networking program, and the phone book
entry you just created should be selected in the Phonebook entry to dial text
box.
33. Click the Dial button.
34. A window will appear asking for a username, password, and domain. The
first two are required.
35. Do not enter anything for the Domain.
36. There is also an option to Save Password, which can be selected if desired.
37. Click
OK to dial into EPI.
38. Once you are connected, a window will appear informing you that you have
successfully connected to the Dial-up Server. 39. Click OK to close this window.
You are now connected and may use any internet software such as Internet Explorer
(installed with Windows NT).